Adjusting your enail Coil for the Perfect Fit

Adjusting your Coil for the Perfect Fit

Quartz Domeless Male Nail

Perfectly fit your enail coil around your quartz nail

Quartz Domeless Male Nail

 

Tightening or loosening a coil for a perfect fit is ideal and should be done by anyone trying to achieve the perfect flaovred vaping dab.  Due to the fact that our quartz nails are hand blown there can be slight variances in the diameter of  the nail, so we make the coil 20.1mm to cover this size difference. if you find your coil is lose and you want to tighten it for better heat conduction simply follow these instructions.

How to adjust your the Barrel enail coil that came with your kit

Depending where your coil is snug at or loose at you will be twisting the coil clockwise or counterclockwise with your hand gently.

When adjusting your coil always keep in mind you must keep it straight and aligned. Be careful not to bend unevenly, or the coil could become crooked and slightly less efficient at transferring heat. If this happens just press firmly back the other way and use your hand to twist it tight. Follow the rest of the procedure — only in reverse.

To avoid crooked results: focus on keeping the top and bottom wraps from shifting horizontally when you start twisting. Use one hand to make sure the coil remains vertically aligned while twisting by put pressure on the top and opposite bottom sides that want to pop out. If you let these two areas bend out you might end up with a shifted coil that won’t fit the banger very well (or at all).  These two opposite points tend to move out of wack as you twist the coil one way or the other, so just watch that as you go.

Bend slowly: After everything is positioned and snug, start bending very slowly, steadily, and firmly. Bend it a little further than you need it to go.

Repeat and test: Do a few cycles of this and notice the small differences each time. It’s also better not to go too fast because it’s easy to get the coil crooked and un-even. If you do small increments it’s easy to correct any over-compensation.

Coil & Banger Fitment Solved

Using this technique I shaved 1-2 mm from the diameter of my heat coil to make a much tighter fit for my banger. I left a very minuscule amount of wiggle room to keep the quartz from being crunched after it heats up the coils expands more but when it cools it condenses. Over months the coil repeatedly being heated and coiled can cause the metal to realign become more hardened and shrinking the diameter which will require loosening if it ever seems too stiff in the coil loop. Also in some instances leaving a little room since a property of quartz is that it can expand faster than the coil and crack of the quartz.

If your enail coil is snug on the top 3 wraps then you will hold the coil with the arm at the top and grasp with your hand, then twist coil clockwise to loosen and counterclockwise to tighten.

If it is snug on the bottom three wraps fits you will then need a pair of needle nose pliers or a regular pliers tool ready. To adjust the coils you will want to flip it over so the arm is on the bottom. You will take the nose of the pliers and stick it through the bottom hole in the coil. Then grasp the coil in your hand and again twist clockwise to loosen and counterclockwise to tighten it.

The banger should be able to slip in and out of the coils by hand, but should keep a nice flush snug fit with the coil sides as well and not fall when left alone. If you have any questions or concerns about adjusting your enail coil to fit your banger nail please do not hesitate to contact our customer support. We are always more than happy to help in any way we can.

 

 

 

if you need help getting your enail setup click here to get your enail setup perfectly